Howa Tactical Bolt Knob

Easy installation and free from slip. Easy, inexpensive, DIY upgrade.

works great

much easier to operate the bolt well worth the money

Love it, simple and effective.

This fits my Ruger American Predator nearly perfect. Has a slight gap near the top but isn't noticeable unless up close. Makes cycling the bolt much easier. Shipped fast, ordered Wednesday and had it Friday.

Outstanding addition to my Howa 1500. The short bolt handle and small bolt knob on the stock rifle made it a little awkward to operate the bolt, especially while wearing gloves. There just wasn't much to grab, and your thumb knocked against the scope when you opened the bolt. But now there's plenty of room for a comfortable and ergonomic grip on the bolt knob with some daylight between your thumb and the scope when you open the bolt. It's an absolute must for any tactical application.

It comes with two small rubber washers to grip the bolt head more firmly, but I found it actually clamps tighter and works better with just one.

Good looking knob, easy install, only used one O-ring. Don't be an idiot like me and not realize there are two lengths of screws for the three holes, and punch the long one right through the handle because you put it in a short hole. Cleaned up well, still looks good.

Simple, inexpensive and it looks great! Like Bryan said, the included O rings don't fit all that well. I used a very small patch of balloon rubber on one side of the knob and everything clamped up tightly.

Don't hesitate to order from Tactical Works. Lisa and the gang will take good care of you!

the rubber o-rings were too big for my application. The sides would not come together completely. I use 5 minute epoxy instead. Once dry the bolt handle looked like it was a single part of the bolt

Easy install, nice fit and finish. I put this on a Howa mini and only used 1 of the supplied O rings. I did put a dab of blue loctite on each screw and let it dry before tightening it down. No wiggle no wobble. I’m happy with the purchase and would buy again.

Bolt knob worked great. The o rings included were actually a little to thick to completely close the gap. I looked in my o ring kit and tried a few thinner o rings and the gap is nearly gone. This is on an 80s model Howa action so the bolt may be slightly different than the newer models. Great solid product.

Bolt Knob worked great. Thanks.

Works great. Easy to install.

Fit my Howa miniaction bolt using just one O-ring. I could not believe how much easier it is to use the bolt now. Would buy again.

works well

Was about like other reviews. Is not seamless but doesn't need to be. Holding up well.

This product is great! I installed it in under 10 minutes and it fit perfect for the Howa 1500 Mini. I have read several reviews where people didn't use the supplied o-rings, but for me I used one and it tightened down without a gap.

I purchased this to use with a Weatherby Vanguard chambered in .300 Win Mag. It fits and functions perfectly. Didn't need the O rings

A perfect fit and easy installation. Excellent product to forego the expensive gunsmith installation of a thread knob. Nice to be able to convert that Vanguard back to stock in 30 years when it becomes a collectable!

Easy installation. Good fit and finish. Does what it’s supposed to. Overall I am very happy with my purchase. Tactical works gets 5 stars as well for a easy and flawless purchase. I appreciate that

Howa Tactical Bolt Knobs fit & function & beat threaded knobs by a longways in strength because the one piece bolt-body/bolt-handle remain complete & are integral with just the addition of the knob.....Thanks for the best money can buy in production or custom.

Works great. Huge upgrade.

Great product,fits well and enhances looks and function of bolt handle!

Great improvement! Mad the bolt run smooth only thing is the edges of the grove is a little rough

Great addition to the Howa mini. Much easier to work the bolt with this clamp on knob. Shipping was very fast. Happy with purchase from Tactical Works.