2 results found
Show results 1 - 2
Chris Crews
The quality will not disappoint. Some very very light sanding to get the BDM to slip into place was done with 300 grit paper by hand. Attached the Receiver and torqued down the Torx screws. Was ringing the gong at 600 yds a few minutes later.
Didn't know what to expect when I ordered this stock, but I'm very pleased with it. The inletting is superb for the Badger M5. I actually expected the stock to weigh more, but this could definitely be shoulder fired without any problems. Can't wait to go the range tomorrow and see how tight I can get the groups. I'm sure I won't be disappointed.