Tikka T3 Extractor Ejector Kit by Lumley

The Tikka T3 Extractor Ejector Kit by Lumley is a higher quality, lower-cost alternative to the factory 'bolt spare parts' kit. This kit is significantly tougher than the factory original and can be used to replace damaged components from cartridge case failures or from just general wear and tear.

There are six separate components to this kit. Lumley's ejector, extractor, and extractor plunger are CNC machined from tool-grade stainless steel, which has been furnace hardened to HRC 35 (322 Brinell) then finished with a TiN PVD coating (gold color). The roll pin retaining the ejector is stainless steel, and the ejector spring and extractor spring are both zinc-plated spring steel. 

It is relatively easy to replace these components within a few minutes with basic hand tools when on an expedition or out in the field somewhere without workshop access. The kit can also be used for converting bolts utilizing a circlip extractor to a Sako-style extractor system (gunsmith fitting required).

Notes:

• Will fit the Sako A7 and Tikka T3/T3x in any factory chambering
• Extractor (only) fits the Tikka 558, 658, 590, 690, 595, 695 for all chamberings with a nominal 9.6mm (0.376") rim diameter, i.e, 222 Rem, 204 Ruger, etc.
• The extractor components can be used to convert bolts of other brands to a Sako style extractor system, such as the Remington 700 with its riveted-in circlip extractor (gunsmithing required)
• The ejector components can be used to convert your Tikka or Sako bolt face to dual ejectors, to change the ejection angle of spent cases and/or increase ejection force (gunsmithing required)
• Tools required are a small pin punch and small gunsmith's hammer, magnetic parts dish optional
• Ensure the firing pin assembly has been removed from the bolt prior to driving out the ejector roll pin
• Care needs to be taken not to lose these small components when under spring pressure. Try assembling within the confines of a large plastic bag for containment.